UV DTF Application Instructions
UV DTF transfers are designed for hard surfaces only and require no heat. Follow these steps carefully to achieve a smooth, long-lasting finish.
What You Need
- UV DTF Transfer (with clear carrier sheet)
- Clean, dry surface
- Squeegee or firm card (recommended)
Surface Compatibility
UV DTF works best on smooth, hard surfaces such as:
- Glass
- Plastic
- Metal
- Acrylic
- Wood (sealed/smooth)
- Tumblers & drinkware
⚠️ Not recommended for:
- Fabric
- Silicone
- Textured or rough surfaces
Step-by-Step Application
1. Clean the Surface
- Wipe the surface with alcohol or a clean cloth
- Remove dust, oil, or moisture
👉 This step is critical for proper adhesion.
2. Peel the Backing
- Carefully peel the white backing away from the design
- The design should remain on the clear carrier sheet
3. Position the Design
- Place the transfer onto your surface
- Align carefully before pressing
⚠️ Once applied, it cannot be repositioned.
4. Apply Pressure
- Use a squeegee or firm card
- Press from the center outward to remove air bubbles
👉 Apply even, firm pressure across the entire design.
5. Peel the Carrier Sheet
- Slowly peel off the clear top film
- Peel at a slight angle
👉 If any part lifts, press again and re-peel slowly.
Curing & Handling
- Allow the design to set for 24 hours before heavy use
- Adhesion strengthens over time
Care Instructions
- Hand wash only (for drinkware)
- Avoid soaking for long periods
- Do not scrub aggressively
- Not dishwasher safe (unless specified)
Common Mistakes to Avoid
- ❌ Applying to dirty or oily surfaces
- ❌ Rushing placement (cannot reposition)
- ❌ Skipping pressure step
- ❌ Applying on textured surfaces
- ❌ Peeling too fast
Pro Tips for Best Results
- Work in a clean, dry environment
- Use strong, even pressure
- Apply slowly and carefully
- Practice on a test surface if needed
Need Help?
If you have questions or need assistance:
📞 919-533-7944
📧 info@sassydamedesigns.com
💬 Use the Chat With Us feature